Bonjour a tous
Je fait une recherche du sat 28.4 il me trouve toutes les chaines ainsi que les chaines 28.2 mais après les chaines 28.2 reste en gris (Ne fonctionne pas).
J'ai juste le sat qui fonctionne 28.4 mais pour trouvé un favoris de chaines impossible.
Comment faire pour faire fonctionner le sat 28.2 ...
y a t'il une solution??
merci pour les réponse
le problème et connu mais je ne comprend pas voila..
Even though you know that both positions 28.2 and 28.4 refer to the same satellite, they are stored internally with different identities.
If you mix settings that expect one position with settings that expect another, for instance by downloading a group of settings, the entire group of channels will not be found because the settings will refer to a position that isn't actually recorded in your satellites.xml file.
I had this problem with 28.2 recently. All the bouquets referred to an essentially non-existant satellite.
The bouquets that had the bad entries were like this:
#SERVICE: 1:0:1:1a30:7dd:2:11a0000:0:0:0:
whereas the newly searched ones had
#SERVICE: 1:0:1:1a30:7dd:2:11c0000:0:0:0:
IF you look at these in HEX, you will see that 0x11a = 282 and 0x11c = 284.
Technically you could adjust them all with a text editor
Je fait une recherche du sat 28.4 il me trouve toutes les chaines ainsi que les chaines 28.2 mais après les chaines 28.2 reste en gris (Ne fonctionne pas).
J'ai juste le sat qui fonctionne 28.4 mais pour trouvé un favoris de chaines impossible.
Comment faire pour faire fonctionner le sat 28.2 ...
y a t'il une solution??
merci pour les réponse
le problème et connu mais je ne comprend pas voila..
Even though you know that both positions 28.2 and 28.4 refer to the same satellite, they are stored internally with different identities.
If you mix settings that expect one position with settings that expect another, for instance by downloading a group of settings, the entire group of channels will not be found because the settings will refer to a position that isn't actually recorded in your satellites.xml file.
I had this problem with 28.2 recently. All the bouquets referred to an essentially non-existant satellite.
The bouquets that had the bad entries were like this:
#SERVICE: 1:0:1:1a30:7dd:2:11a0000:0:0:0:
whereas the newly searched ones had
#SERVICE: 1:0:1:1a30:7dd:2:11c0000:0:0:0:
IF you look at these in HEX, you will see that 0x11a = 282 and 0x11c = 284.
Technically you could adjust them all with a text editor
