Vous utilisez un navigateur non à jour ou ancien. Il ne peut pas afficher ce site ou d'autres sites correctement. Vous devez le mettre à jour ou utiliser un navigateur alternatif.
starsat sr-2000hd hyper a la fin il se bloque en "end"
bonjour omar hi flashato le starsat avec un firmware définitivement mal à la fin je suis resté avec end sur le display écrite, je l'ai éteint et après le dysplay était san rien ecrite , noire , selement la lumier verd du tast power . j'ai essayé avec des ailes 2, 6 pour lui envoyer la boot loader e le dump leader avec la procedur le loader SR-2000 HYPER: http://adf.ly/wOPyL
Si le pc ne dispose pas d'une prise rs232 alors rajouter cet adaptateur:
- Etteindre avec le bouton arrière le demo - Retirer la cles wifi à l'avant et la cles usb à l'arrière de l'appareil - Débrancher tous les câbles, à savoir: celui qui relie le demo à la TV (hdmi ou péritel), le câble ethernet et le câble coaxial relié à la parabole. - Relier la tour au demo avec le câble rs232 en vissant les 4 vis pour plus de sécurité. Voici un tuto: ATTENTION demo etteint electriquement avec le bouton arrière avant de commencer la manipulation. Comment Flasher par le Loader ? voici comment faire : - On lance le loader puis on appuie sur "open" - on cherche le firmware, puis on appuie sur "Start" - quand on aura le message sur l'ecran, on branche le démo au courant Electrique pour que le démo commence le flashage , on le laisse faire jusqu’à ce qu'il redémarre automatiquement, NB : le flashage peut prendre quelques minutes ,,,,, mais rien da faire le décodeur donne aucun signe de vie, j ai provais memme Solution of"Boot"Problem Starsat 2000 HD
Many users of this receiver have faced the Problem of "Boot"
Especially with the"GOODS ARRIVED AFTER FEB 20"
and one of them is the member : "farid01"
who is pretending that we only upload files without helping members
to solve their technical problems !
And Due to his request and after one year of waiting
here is the solution to this problem
So Just Follow the Steps Let's Get Started...
1- Power Off from the back and link your receiver and computer with the RS 232 cable
2- Open the loader putty.exe 0.62
Download it from here :
then Set it as is Shown on the pic below
3- When you press open on the loader
Power on your receiver and you will see a black windows like the one in the Below pic
4- Press Enter On Your Keyboard An d you will Get as Below
5- Now write : "setenv autostart yes" ( separate the words)
Press "Enter" on your Keyborad
6- Now write this : "saveenv"and press Enter
7- Wait till the process completes like the Pic Below